Model 2000 Pneumatic Volume Booster 2000型气动增压器
Part Number: M2000
The Model 2000 Pneumatic Volume Booster converts a low flow signal to a high flow output. It is ideally suited for a variety of applications including the operation of air systems that require rapid valve or cylinder action. With its balanced supply valve and aspirator tube, the M2000 booster will maintain setpoint while delivering a strong boost of volume. In addition, its no bleed soft seat design minimizes air consumption of the system. As a pilot operated regulator design, the M2000 handles up to 250 psig, [17.0 BAR], (1700 kPa) supply pressure. The M2000 provides a flow capacity of 40 SCFM (68 m3/HR), which results in a Cv factor of just less than 1.0 in forward flow mode.
2000型气动增压器将低流量信号转换为高流量输出。它非常适合各种应用，包括需要快速阀门或气缸动作的空气系统的操作。凭借其平衡的供应阀和吸气管，M2000增压器将在提供强劲增压的同时保持设定值。此外，其无放气软座椅设计最大限度地减少了系统的空气消耗。作为先导式调节器设计，M2000可处理高达250 psig[17.0 BAR]（1700 kPa）的供应压力。M2000的流量为40 SCFM（68 m3/HR），这使得正向流动模式下的Cv系数略小于1.0。
Features 特征
Flow capacity of 40 SCFM (68 m3/HR)
流量为40标准立方英尺/分钟（68立方米/小时）
Balanced supply valve
平衡供应阀
Aspirator tube design
吸气管设计
Soft supply and exhaust valve seats
软供气和排气阀座
Small signal volume
信号音量小
A separate control chamber isolates the diaphragm from the main flow
一个单独的控制室将隔膜与主流隔离开来
Unit construction
单位建设
Benefits 好处
Provides fast responsive operation
提供快速响应的操作
Minimizes the effect of supply pressure variation
将供应压力变化的影响降至最低
Minimizes downstream pressure droop under flow conditions
在流动条件下尽量减少下游压力下降
Provides high forward and exhaust flows
提供高向前和排气流量
Minimizes air consumption
最大限度地减少空气消耗
Assures rapid response to pressure variation
确保对压力变化做出快速反应
Eliminates any hunting and buzzing
消除任何狩猎和嗡嗡声
Allows you service the unit without removing it from the line
允许您在不将其从生产线上卸下的情况下对设备进行维修
